1 2 Copyright This manual is copyrighted with all rights reserved. No portion of this manual may be copied or reproduced by any means without the pri
19 7. Performing Calibration 1. Keep pressing the feed button while turning on the power, until the printing motor becomes activated. 2. The calibr
21 Parallel Interface Requirements The required cable (IEEE 1284-compliant is recommended) must have a standard 36-pin parallel connector on one end
23 The parameters include: Ports Select the correct port to link with the printer. The port may be one of parallel (LPT), serial (COM), USB001 or F
25 D. Miscellaneous The host shows "Printer Time out" 1. Check if the communication cable( parallel, serial or USB) is connected secure
27 12. Reference Technical Information Specifications MINIMARK Printing method Thermal Transfer Printing resolution 203 dpi (8dots/mm) Printing spe
3 Contents 1. Checking Your Box... 4 2. Power Supply...
5 2. Power Supply WARNING: NEVER OPERATE THE PRINTER AND POWER SUPPLY IN AN AREA WHERE THEY CAN GET WET. 1. The Power Adapter has a barrel connector
7 Ribbon Pick-up Holder Release Levers Media Hanger Ribbon Supply Holder Thermal Printhead 8 4. Loading the Ribbon Note: This secti
9 3. Turn over the print head module to expose the ribbon supply holder. Media Compartment Release Levers Print H
11 7. Turn back the print head module and then insert the bare core into the pick-up holder. (First snap in the right side, then the left side).
13 5. Loading the Media The MINIMARK printer can be operated in two different options: Cutter On / Cutter Off. - In cutter On mode, the printer
15 5. Lead the label through the media guides and the cutter (under the bent black plate) with the other hand. The media guide can be adjusted centra
17 7. Close the top cover and turn on the printer or press the feed button if the printer is already on. Note: The feed but
Comments to this Manuals