Brady Wraptor User's Guide Page 70

  • Download
  • Add to my manuals
  • Print
  • Page
    / 72
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 69
Error Message Possible Cause/Resolution
and reprint the job.
The IP address is invalid. Cause: The user entered an invalid IP address.
Resolution: Check for proper IP address format:
xxx.xxx.xxx.xxx where xxx can be a number from 1 to
255.
The label index is out of range. Cause: Error occurred in moving through label file.
Possible corruption to print file.
Resolution: Reload file and try again.
The label number must be between 1
and %d.
Cause: User entered a label number outside the range
of labels in the opened file in the Go To Label dialog.
Resolution: Enter a number in the label range. Label
range is displayed in the Run tab.
The port number must be a positive
integer between 1 and 9999.
Cause: Printer Port number must be greater than zero
and less than 10000. The default port number is 9100.
Resolution: Use default number of 9100.
The selected file %s is read-only. Do
you want to delete it?
Cause: The user pressed the delete button and the
selected file has a read-only attribute.
Resolution: It is OK to delete Read-Only files. This
message simply distinguished them from non-Read-
Only files.
The print file uses label size: %s. A
different label size is loaded in the
printer. Do you want to proceed
anyway?
Cause: User opened a print file designed with a
different label size than currently loaded in the printer.
Resolution: Override and proceed with caution or
cancel open operation and load correct label material
in printer before running print job.
The serial port is currently used for PC
connection. Please change connection
type first.
Cause: User try to establish a remote control
connection with the Connection Type set to Serial in
the Config tab.
Resolution: Remote control and Connection Type =
serial cannot be used at the same time. Select a
different Connection Type in the Config tab menu
before attempting to use remote control.
The serial port is currently used for
Remote Control. Please change to
Local Control first.
Cause: See “Cannot change connection to serial port.
It's used by remote control.”
Resolution: Shut down remote control mode by
pressing the Local Control button in the Config tab.
Then select the Serial connection type.
The total Left Margin Offset setting of
%d pixels is out of range. Upper limit
of 90 pixels is used.
Cause: Remote Control Message. Parameter Out of
Range.
Resolution: Reduce Adjustment to be within range
allowed.
The total Left Margin Offset setting of
%d pixels is out of range. Upper limit
of -90 pixels is used.
Cause: Remote Control Message. Parameter Out of
Range.
Resolution: Reduce Adjustment to be within range
allowed.
Wraptor™ User’s Guide 63
Page view 69
1 2 ... 65 66 67 68 69 70 71 72

Comments to this Manuals

No comments